Furnace Repair in Salisbury, NC
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Rowan County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and nights near freezing
Furnaces in Salisbury run from October through April, seven months of the year. Winter nights average 31°F from December through February, so the burner is cycling on and off most nights to keep up. Every cycle depends on the igniter lighting the burner cleanly, and that part wears a little more with each start.
Most homes here heat with electricity, and the power does not always stay on through a storm. Rowan County has seen 7 winter storms and 101 damaging wind events over the past ten years, and across North Carolina a quarter of households lost power for at least 24 hours in 2024. When the power drops mid-cycle and comes back, a furnace that will not restart on its own is worth checking rather than waiting out.
- 7 months
- October through April, your furnace is on duty
- 31°F
- the average winter night it heats against
- 7 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
North Carolina requires HVAC contractors to hold a state license.
The State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors is the one that issues this license, and it tested the contractor before handing it over. The license belongs to the contractor, not to the job, so the same license that covers a furnace repair in Rowan County covers any other heating or cooling work that contractor takes on elsewhere in the state.
For a furnace repair, that license is what stands behind the person working on your gas connections. A bad connection is the part of this job that can hurt someone, and the state has already checked that this contractor knows how to do it right before letting them near your furnace.
Sources: North Carolina General Assembly · North Carolina State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors
- Why won't my furnace turn on?
- Most often the thermostat isn't sending power to the furnace, or the furnace isn't getting power itself. Check the breaker first, then check the thermostat batteries and its setting. If those are fine, the igniter may have failed, or a safety switch has tripped because of a clogged filter or blocked vent. A furnace won't run at all if the safety switches sense a problem, even a small one, so a contractor needs to find out which one tripped and why.
- Why is my furnace blowing cold air?
- If air is moving but it's not warm, the furnace may be running the blower without the burners lighting. That points to the igniter, the flame sensor, or a gas supply issue. It can also mean the thermostat fan is set to "on" instead of "auto", which pushes air through the ducts even when the burners aren't firing. With lows averaging 31°F through the winter here, a furnace that won't actually heat needs attention fast, so a contractor should check it before the next cold night.
- Why won't my furnace pilot light stay lit?
- A pilot that keeps going out is usually a sign the thermocouple has worn out and can no longer hold the gas valve open. It can also mean a draft is reaching the pilot from a blocked or damaged vent. Either way it's a gas safety issue, not something to keep relighting on your own. A contractor can test the thermocouple and check the vent to find out which one it is.