HVAC Repair in Greenville, NC
Homes here need heat from November through March and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Pitt County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of work a year, in Pitt County heat and cold
Your system in Greenville runs heat November through March and cooling May through September. Ten months of the year, something is always cycling on to keep the house comfortable.
Summer afternoons averaging 88°F keep the compressor working hard for five straight months. Winter nights average 34°F, cold enough that the furnace or heat pump cycles on and off through the night to hold the temperature. Most homes here heat with electricity, so when a heat pump or blower motor starts struggling, there is no backup system keeping the house warm while it waits on a fix. Pitt County has also seen 67 damaging wind events and 6 winter storms over the past ten years, and a quarter of North Carolina households lost power for a full day or more in 2024. Power drops and surges wear on the boards and controls that keep a system running, and a system already worn from months of steady use has less room to absorb that kind of hit.
- 5 months
- November through March, your system heats
- 5 months
- May through September, it cools
- 34°F
- the average winter night it heats against
- 88°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
North Carolina requires HVAC contractors to hold a state license.
The State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors licenses HVAC contractors in North Carolina. That license belongs to the contractor, not to the job, so the same license covers this repair and every other job they take on.
For a repair to a heating and cooling system, that license is what the state has put on record for the person doing the work. It is tied to the contractor's name, not to this one visit, and it stands behind whatever job they take on next.
Sources: North Carolina General Assembly · North Carolina State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors
- Why is my heat not working?
- Start with the thermostat. Check that it is set to heat and set a few degrees above room temperature, then check the breaker for the furnace or air handler. Most homes here heat with electricity, so a tripped breaker or a dead thermostat battery is worth ruling out before anything else. If power and settings check out and the system still will not fire, the igniter or a safety switch is the likely cause, and that is a job for a licensed contractor.
- Why is my system running but not cooling the house?
- Check the air filter first. A clogged filter starves the system of airflow, and on an 88°F afternoon that shows up fast as warm air from the vents. Next check that the outdoor unit is running and not covered in leaves or grass clippings, since it needs open airflow to move heat outside. If the filter is clean and the outdoor unit runs but the house still will not cool down, the refrigerant charge or the coil needs a contractor to look at it.
- What can I check before calling for HVAC repair?
- Check the thermostat settings and batteries, the breaker for the system, and the air filter. These take a couple of minutes to rule out. If the outdoor unit is part of the problem, look for anything blocking it, like leaves or a fallen branch after a storm. Past that point, stop. Opening the furnace cabinet or the outdoor unit is a job for a licensed contractor, and North Carolina requires one for this work.